Methods The samples discussed here are fabricated using solid-source molecular beam epitaxy on (001) GaAs substrates with a valved cracker cell for As4 supply. The Ga flux is adjusted for a GaAs growth rate of 0.8 monolayers (ML)/s.

The As flux during GaAs buffer layer growth corresponds to a flux gauge reading of 1 ×10−5 Torr. During droplet etching, the As flux is minimized to less than 1 ×10−7 Torr by closing the As valve, the As cell shutter GDC-0068 purchase and in addition the main shutter in front of the sample during annealing. After growth of a 100-nm-thick GaAs buffer layer at a temperature T = 600℃ to smooth the surface, the As shutter and valve are closed and the temperature is increased to the annealing temperature of 630℃ to 670℃. Ga is the deposited for 2.5 s corresponding to a droplet material coverage θ= 2.0 ML. After deposition of the droplet material, the initial droplets are transformed into nanoholes during post-growth annealing for a time t a. After annealing, the samples are quenched by switching off the substrate heater. Figure 1a shows a sketch of the whole process including the shape modification of the droplet etched nanoholes during long-time annealing,

and Figure 1b,c displays typical atomic force microscopy (AFM) images visualizing the different stages. Evofosfamide in vivo results and discussions The purpose of this study is to examine droplet Docetaxel in vivo etching processes at high temperature. Previously, the generation of nanoholes by LDE with Ga droplets has been demonstrated in the temperature regime between 570℃ and BIBW2992 supplier 620℃

[13]. Figure 2a,b establishes that droplet etching with Ga on GaAs is possible also above the congruent evaporation temperature of 625℃ [21, 22]. The holes have an average depth of 68 nm at T = 650℃ (Figure 2c) which is more than four times deeper compared with previous Ga-LDE results [13]. A summary of the temperature-dependent structural characteristics of the nanoholes is plotted in Figure 2d. The hole density N decreases with T in accordance with previous results on Ga- [13] or Al-LDE [23]. A particularly interesting observation is that the holes have very low densities (≃106 cm −2). This demonstrates that high T droplet etching can be used to generate low-density nanohole templates for the subsequent creation of well-separated nano-objects following deposition. The hole diameter increases with T, which is related to the increasing volume of the initial droplets V≃θ/N at conditions with reduced density N. Also, the hole depth increases with T. This temperature-dependent trend of hole depth is in agreement with previous experimental results [13, 23] and has been modelled by a simple scaling law with a temperature-dependent etching rate [23].